Installation manual

Command Manual - STP
Quidway S3000-EI Series Ethernet Switches Chapter 1 MSTP Configuration Commands
Huawei Technologies Proprietary
1-30
1.1.32 stp region-configuration
Syntax
stp region-configuration
undo stp region-configuration
View
System view
Parameter
None
Description
Using stp region-configuration command, you can enter MST region view. Using
undo stp region-configuration command, you can restore the default MSTP region
configurations.
By default, the three MST region parameters take the default values. The MST region
name of the switch is the first MAC address, all the VLANs are mapped to CIST, and
MSTP revision level takes 0.
You can enter MST region view, using the stp region-configuration command. And
then you can configure the parameters including region name, revision level, and VLAN
mapping table of the region.
Example
# Enter MST region view.
[Quidway] stp region-configuration
[Quidway-mst-region]
1.1.33 stp tc-protection
Syntax
stp tc-protection enable
stp tc-protection disable
View
System view
Parameter
None