Installation manual

Command Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches
Chapter 3 Multicast MAC Address for Cluste
r
Management Commands
Huawei Technologies Proprietary
3-2
Parameter
time-interval: Time interval for sending multicast messages, in minutes.
Description
Use the cluster-mac syn-interval command to set the time interval for sending
multicast messages on the management device. You can only use this command on
the management device.
If the time interval for sending multicast messages is set to 0, the management device
does not send multicast messages to the cluster member switches.
Example
# Set the time interval for sending multicast messages to 1 minute.
[huawei_0.Quidway-cluster] cluster-mac syn-interval 1