Installation manual

Command Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches Chapter 2 QoS Commands
Huawei Technologies Proprietary
2-16
Example
# Configure “COS->Local-precedence” map.
[Quidway] qos cos-local-precedence-map 0 1 2 3 4 5 6 7
After the configuration, the “COS->Local-precedence” map is shown in Table 1-6.
Table 2-10 “COS->Local-precedence” map
COS Value Local Precedence
0 0
1 1
2 2
3 3
4 4
5 5
6 6
7 7
2.1.16 queue-scheduler
Syntax
queue-scheduler { strict-priority | wrr queue1-weight queue2-weight queue3-weight
queue4-weight | wrr-max-delay queue1-weight queue2-weight queue3-weight
queue4-weight maxdelay }
undo queue-scheduler
View
System view
Parameter
strict-priority: Configures to perform strict priority scheduling.
wrr queue1-weight queue2-weight queue3-weight queue4-weight: Configures to
perform WRR scheduler. queue1-weight: Specifies the weight (percent of bandwidth
assigned) 1. queue2-weight: Specifies the weight of the queue 2. queue3-weight:
Specifies the weight of the queue 3. queue4-weight: Specifies the weight of the queue
4.
wrr-max-delay queue1-weight queue2-weight queue3-weight queue4-weight
maxdelay: Configures to perform Delay bounded WRR scheduler. queue1-weight:
Specifies the weight (percent of bandwidth assigned) 1. queue2-weight: Specifies the