Installation manual

Command Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches Chapter 1 ACL Commands
Huawei Technologies Proprietary
1-4
Description
Using display acl running-packet-filter all command, you can view the information
about the running state of the ACL. The displayed information includes ACL name, rule
name and running state.
Example
# Display the ACL running state on all the interfaces.
<Quidway> display acl running-packet-filter all
acl std1 rule 0 running
acl std1 rule 1 running
The display information shows all the activated ACLs of the switch.
1.1.4 display time-range
Syntax
display time-range { all | name }
View
Any view
Parameter
all: Configures to display all the time range.
name: Specifies the name of the time range.
Description
Using display time-range command, you can view the configuration and status of the
current time range. You will see the active or inactive state outputs respectively.
Note that the system has a delay of about 1 minute when updating the ACL state,
while the display time-range command applies the current time. Therefore when
display time-range displays that a time range is active, the ACL using it may not have
been activated. This is a kind of normal case.
Example
# Display the configuration of all the time ranges.
<Quidway> display time-range all
Current time is 14:36:36 4-3-2003 Thursday
Time-range : hhy ( Inactive )
from 08:30 2-5-2005 to 18:00 2-19-2005
Time-range : hhy1 ( Inactive )