Installation manual

Command Manual - Multicast
Quidway S3000-EI Series Ethernet Switches Chapter 2 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
2-9
undo igmp-snooping max-response-time
View
System view
Parameter
seconds: Maximum response time for a query ranging from 1 to 100 and measured in
seconds; By default, 10.
Description
Using igmp-snooping max-response-time command, you can configure the
maximum response time for a query. Using undo igmp-snooping
max-response-time command, you can restore the default value.
The set maximum response time decides the time limit for the switch to respond to
IGMP Snooping general query packets.
For the related command, see igmp-snooping, igmp-snooping router-aging-time.
Example
# Configure to respond the IGMP Snooping packet within 50s.
[Quidway] igmp-snooping max-response-time 50
2.1.11 igmp-snooping router-aging-time
Syntax
igmp-snooping router-aging-time seconds
undo igmp-snooping router-aging-time
View
System view
Parameter
seconds: Specifies the router port aging time, ranging from 130 to 1000 measured in
seconds; By default, 260.
Description
Using igmp-snooping router-aging-time command, you can configure the router port
aging time of IGMP Snooping. Using undo igmp-snooping router-aging-time
command, you can restore the default value.
The port here refers to the Ethernet switch port connected to the router. The Layer-2
Ethernet switch receives general query packets from the router via this port. The timer
should be set to about 2.5 times of the general query period of the router.