Installation manual

Command Manual - Multicast
Quidway S3000-EI Series Ethernet Switches Chapter 2 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
2-8
[Quidway] acl number 2001
[Quidway-acl-basic-2001] rule deny source 225.0.0.0 0.0.0.255
[Quidway-acl-basic-2001] rule permint source any
z Create VLAN 2, and add Ethernet 0/2 to it.
[Quidway] vlan 2
[Quidway-vlan2] port Ethernet 0/2
z Set the filtering of IGMP Snooping Report packets applied to ACL 2001 of VLAN 2
on Ethernet 0/2.
[Quidway] interface Ethernet 0/2
[Quidway-Ethernet0/2] igmp-snooping group-policy 2001 vlan 2
2.1.9 igmp-snooping host-aging-time
Syntax
igmp-snooping host-aging-time seconds
undo igmp-snooping host-aging-time
View
System view
Parameter
seconds: Specifies the port aging time of the multicast group member, ranging from 200
to 1000 and measured in seconds; By default, 260.
Description
Using igmp-snooping host-aging-time command, you can configure the port aging
time of the multicast group members. Using undo igmp-snooping host-aging-time
command, you can restore the default value.
This command is used to set the aging time of the multicast group member so that the
refresh frequency can be controlled. When the group members change frequently, the
aging time should be comparatively short, and vice versa.
For the related command, see igmp-snooping.
Example
# Set the aging time to 300 seconds.
[Quidway] igmp-snooping host-aging-time 300
2.1.10 igmp-snooping max-response-time
Syntax
igmp-snooping max-response-time seconds