Installation manual

Command Manual - Multicast
Quidway S3000-EI Series Ethernet Switches Chapter 2 IGMP Snooping Configuration Commands
Huawei Technologies Proprietary
2-4
Parameter
interface_type: Port type.
interface_number: Interface number.
interface_name: Interface name, expressed as interface_name=interface_type
interface_number.
Description
Use the display multicast-source-deny command to display configuration
information about multicast source port checking.
If the port type and port number are not specified, the multicast source port checking
information about all ports on the switch is displayed; if only the port type is specified,
the multicast source port checking information about all ports of this type is displayed; if
both the port type and port number are specified, then the multicast source port
checking information about this port is displayed.
Example
# Display the state of multicast source port suppression on ethernet 0/1.
[Quidway] display multicast-source-deny ethernet 0/1
# Display the state of multicast source port suppression on all 100 Mbps Ethernet ports.
[Quidway] display multicast-source-deny interface ethernet
2.1.5 igmp-snooping
Syntax
igmp-snooping { enable | disable }
undo igmp-snooping
View
System view
Parameter
enable: Enable IGMP Snooping.
disable: Disables IGMP Snooping; By default, the switch disables IGMP Snooping
feature.
Description
Using igmp-snooping command, you can enable/disable IGMP Snooping. Using
undo igmp-snooping command, you can restore the default setting.
This command is used to enable or disable IGMP Snooping on the switch.