Installation manual

Operation Manual - Multicast
Quidway S3000-EI Series Ethernet Switches Chapter 2
IGMP Snooping Configuration
Huawei Technologies Proprietary
2-5
IGMP Snoop RP cannot run at the same tim ck if GMRP is
r tat ling IGMP
S
By default, IGMP Snooping is disabled.
2.2.2 Con
y general query message from the router before the router port is aged, it
lticast group.
Perform the following configuration in system view.
ing and GM e. You can che
unning, using the display gmrp s us command, in any view, before enab
nooping.
figure Router Port Aging Time
This task is to manually configure the router port aging time. If the switch has not
received an
will remove the port from all the MAC mu
Table 2-2 Configure router port aging time
Operation Command
Configure router port aging time igmp-snooping router-aging-time seconds
Restore the default aging time undo igmp-snooping router-aging-time
By default, the port aging time is 260s.
2.2.3 Configure Maximum Response Time
This t e the maxi ch
receives no
e port from the multicast group.
stem view.
ask is to manually configur
report message from a port in the maxim
mum response time. If the Ethernet swit
um response time, it will remove
th
Perform the following configuration in sy
Table 2-3 Configure the maximum response time
Operation Command
Configure the maximum response
time
igmp-snooping max-response-time
seconds
Restore the default setting undo igmp-snooping max-response-time
By default, the maximum response time is 10 seconds.
2.2.4 Configure Agi f Multicast Group Mem
T g ast gro
swit receives no multicast group rep ge during the member port aging time,
ng Time o ber
his task is to manually set the agin
ch
time of the multic up member port. If the
ort messa