Installation manual

Operation Manual - VLAN
Quidway S3000-EI Series Ethernet Switches Chapter 2
Isolate-User-Vlan Configuration
Huawei Technologies Proprietary
2-1
r-vlan to secondary VLAN
The t ble the isolate-user-vlan.
2.2.1 Configure isolate-user-vlan
You can use the following commands to create an isolate-user-vlan for an Ethernet
ure it as an isolate-user-vlan and add new ports to
ure isolate-user-vlan
Chapter 2 Isolate-User-Vlan Configuration
2.1 Isolate-user-vlan Overview
Isolate-user-vlan is a new feature of the Ethernet Switches launched by Huawei
Technologies Co., Ltd., through which can save the VLAN source. isolate-user-vlan
adopts the Layer-2 VLAN architecture. (On an Ethernet Switch configure the
isolate-user-vlan and Secondary VLAN.) An isolate-user-vlan corresponds to several
Secondary VLANs. The isolate-user-vlan includes all the ports and Uplink ports of the
corresponding Secondary VLANs. In this way, a upstream switch only needs
recognizing the isolate-user-vlan of the downstream switch and ignores those
Secondary VLANs, thereby streamlining the configuration and saving the VLAN source.
You can use isolate-user-vlan to implement the isolation of the Layer-2 packets through
assigning a Secondary VLAN for each user, which only includes the ports and the
Uplink ports connected to the user. You can put the ports connected to different users
into one Secondary VLAN to implement the Layer-2 packet intercommunication.
2.2 Configure isolate-user-vlan
Isolate-user-vlan configuration includes:
z Configure isolate-user-vlan
z Configure secondary VLAN
z Configure to map isolate-use
asks above are required to be configured once you ena
switch and add new ports to it.
Create a VLAN in system view, config
it in VLAN view.
Table 2-1 Config
Operation Command
Create a VLAN
vlan vlan-id
Configure the VLAN as isolate-user-vlan
r-vlan enable
isolate-use
Cancel the configuration of VLAN as
isolate-user-vlan
undo isolate-user-vlan enable