Installation manual

Operation Manual - VLAN

Quidway S3000-EI Series Ethernet Switches Chapter 1

VLAN Configuration

Huawei Technologies Proprietary

1-2

e switch.

Note that you prompt when creating VLAN ature is disabled.

1.2.2 Crea

You can use the following command to create/delete a VLAN.

By default, VLAN feature is enabled on th

will see error after VLAN fe

te/Delete a VLAN

Perform the following configurations in system view.

Table 1-2 Create/Delete a VLAN

Operation Command

Create a VLAN and enter the VLAN view vlan vlan_id

Delete the specified VLAN undo vlan { vlan_id [ to vlan_id ] | all }

If the VLAN to be created exists, enter the VLAN view directly. Otherwise, create the

VLAN first, and then enter the VLAN view.

vlan_id specifies the VLA nnot be

1.2.3 Add Ethernet Ports to a VLAN

view.

N ID. Note that the default VLAN, namely VLAN 1, ca

eleted.

You can use the following command to add the Ethernet ports to a VLAN.

Perform the following configuration in VLAN

Table 1-3 Add Ethernet ports to a VLAN

Operation Command

Add Ethernet ports to a VLAN

port interface_list

Remove Ethernet ports from a VLAN

undo port interface_list

By default, the system adds all the ports to a default VLAN, whose ID is 1.

rid port to/from VLAN by port and undo

1.2.4 Set/D Characte

Y et/d aracter string.

erform the following configuration in VLAN view.

Note that you can add/delete trunk port and hyb

port commands in Ethernet port view, but not in VLAN view

elete VLAN Description r String

ou can use the following command to s elete VLAN description ch