Installation manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 5
System IP Configuration
Huawei Technologies Proprietary
5-7
5.2.6 Con
You can use the mmand to configure a static ro to the switch via
th
Perform the following configuration in system view.
Configuring a static route
figuring a Static Route
following co ute for login
e network.
Table 5-7
Operation Command
Add a static route
ip route-static ip-address { mask | mask-length } { null
null-interface-number | gateway-address } [ preference
preference-value ]
Delete a static
undo ip route-static ip-address { mask | mask-length }
route
[ null
null-interface-number | gateway-address ] [ preference
preference-value ]
figuring the Default Preference of Static Routes 5.2.7 Con
s preference is not
Perform the f figurations in system view.
T
The default-preference will be the preference of the static route if it
specified when configured. You can change the default preference value of the static
routes to be configured by using the following command.
ollowing con
able 5-8 Configuring the default preference of static routes
Operation Command
Configure the default preference valu
static routes
atic default-preference
default-preference-value
e of
ip route-st
Remove the default preference value of
undo ip route-static
ce
static routes configure
default-preferen
By default
, its value is 60.
5.3 Disp
After the above configuration, execute display command in any view to display the
t of the configuration.
laying and Debugging System IP
running of the system IP configuration, and to verify the effec