Installation manual

Operation Manual - Remote Power-feeding
Quidway S3000-EI Series Ethernet Switches Chapter 1
Remote Power-Feeding Configuration
Huawei Technologies Proprietary
1-8
II. Networking diagram
Network
S3026C
-
PWR
E0/1
AP AP
E0/2
S2016C
E0/24
Network
E0/1
AP AP
E0/2
S2016C
E0/24
Network
S3026C
-
PWR
E0/1
AP AP
E0/2
S2016C
E0/24
Network
E0/1
AP AP
E0/2
S2016C
E0/24
II
undo poe disable
rough spare lines.
ower of 12000 milliwatt and Ethernet0/2 3000
nsure preferential power supply for its
PDs.
[Quidway-Ethernet0/24] poe priority critical
ment mode in auto mode.
so that it can supply power to
1.4.2 Upg ple
I.
serves as FTP client and the remote PC as FTP server. The configuration
switch, with password hello and with
ctory on the PC. The IP address of a
Figure 1-2 An example for remote power-feeding
I. Configuration procedure
# Enable remote power-feeding on Ethernet0/1, Ethernet0/2 and Ethernet0/24 (this is
the default configuration and can be therefore omitted.)
[Quidway-Ethernet0/1]
[Quidway-Ethernet0/2] undo poe disable
[Quidway-Ethernet0/24] undo poe disable
# Enable Ethernet0/2 to supply power th
[Quidway-Ethernet0/2] poe mode spare
# Set Ethernet0/1 to have a maximum p
milliwatt.
[Quidway-Ethernet0/1] poe max-power 12000
[Quidway-Ethernet0/2] poe max-power 3000
# Set the priority of Ethernet0/24 to be critical to e
# Configure the power manage
[Quidway] poe power-management auto
# Enable the compatibility detection of PDs on the switch
those PDs that do not comply with 802.3af.
[Quidway] undo poe legacy disable
rading PoE daughter-card Configuration Exam
Networking requirements
The switch
on FTP server: Configure a FTP user named as
read & write authority over the Switch root dire