Installation manual

Operation Manual - Remote Power-feeding
Quidway S3000-EI Series Ethernet Switches Chapter 1
Remote Power-Feeding Configuration
Huawei Technologies Proprietary
1-7
eding
eeding
1.3 Displaying Remote Power-Fe
After the above configuration, execute the display commands in any view to display
the running of the remote power-feeding configuration, and to verify the effect of the
configuration.
Table 1-10 Displaying remote power-f
Operation Command
Display the remote power-feeding status display
of specified port or all ports | interface-type interface-num | all }
poe interface { interface-name
Display the power of specified port or all
ports
display poe interface power
{ interface-name | interface-type
interface-num | all }
Display the PoE parameters of PSE
power supply device
display poe powersupply
For details about the refer to the relevant comman
1.4 Conf
1.4.1 Pow
016C Ethernet switch, Ethernet0/2
PWR supply power to its connected devices, including those
non-802.3af-compliant PDs. Among the ports, Ethernet0/2 supply power to outside
ower consumption of 2500 milliwatt and
S2016C 12000 en if the S3026C-PWR supp o the full, PDs
connected to Ethernet0/24 shall be powered preferentially.
parameters, d manual.
iguration Example
er-feeding Supply Configuration Example
I. Networking requirements
Ethernet0/1 of the S3026C-PWR connects to an S2
connects to an Access Point (AP) and Ethernet0/24 is supposed to connect to an
important AP.
The S3026C-
through spare lines. The AP devices have a p
milliwatt. Ev lies power t