Installation manual

Operation Manual - Remote Power-feeding
Quidway S3000-EI Series Ethernet Switches Chapter 1
Remote Power-Feeding Configuration
Huawei Technologies Proprietary
1-2
Network
S3026C
-
PWR
E0/1
E0/2
E0/24
S2016C AP AP
Network
E0/1
E0/2
E0/24
S2016C AP AP
Network
S3026C
-
PWR
E0/1
E0/2
E0/24
S2016C AP AP
Network
E0/1
E0/2
E0/24
S2016C AP AP
Figure 1-1 Remote power-feeding
You can input command lines to enable/disable remote power-feeding on a port, adjust
its power-feeding mode and PD detection mode, and set its power-feeding priority and
ctionality. As such, you can also press the "mode" button to
PDs connected to an S3026C-PWR and allow the
S3026C-PWR to supply power to PDs on spare lines and signal lines simultaneously.
compatibility testing fun
perform reverse detection on the
Table 1-1 Configuring remote power-feeding
Device Configuration Default Description
Enable remote
power-feeding on a port
Enabled -
Press the mode button
on a port
-
to detect power-feeding
-
Select the
eeding through
s
You can adjust the
wer-feeding
ssary.
power-feeding mode on
a port
Power-f
signal line
po
mode if nece
Set the maximum
power
on an 15400 milliwatt
You can adjust this
aximum
according to the
power-feeding port
m
power on the PDs
in practice.
Setting power
management mode
power management
mode is manual mode
t is Low
and Power-Feeding
Priority on a Port
P
riority of a Por
-
Enable/Disable the
compatibility detection Disabled -
on a port
Reset the PoE
configuration on the
switch
-
Yo
default
u can restore
PoE
configuration on
the current switch.
S3026C-
PWR
ard
Upgrading the PoE
Daughter-C
- -