Installation manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 4
User Interface Configuration
Huawei Technologies Proprietary
4-8
 Note:
By default, the password is required for authenticating the Modem and Telnet users
when they log in. If the password has not been set, when a user logs in, he will see the
prompt “
Login password has not been set !”.
If the authentication-mode none command is used, the Modem and Telnet users will
not be required to input password.
II vel used after a user logging in
g the command level used after a user logging
. Setting the command le
The following command is used for settin
in.
Perform the following configuration in local-user view.
Table 4-15 Setting the command level used after a user logging in
Operation Command
Set command level used after a
se
user logging
rvice-type { ftp [ ftp-directory directory ] |
lan-access | ssh [ | telnet [ level
level ] ] | telnet [ lev [ level level ] ] }
in
level level
el level | ssh
Restore the default command
un -directory ] |
lan telnet [ level ] ] | telnet
[ le
level used after a user logging in
do service-type { ftp [ ftp
-access | ssh [ level |
vel | ssh [ level ] ] }
By default, the specified logon user can access the commands at Level 1.
II interface
ommand level after a user logs in from
a specific user interface, so that a user is able to execute the commands at such
Perform the follo ation in user interface view.
T used a
in
I. Setting the command level used after a user logs in from a user
You can use the following command to set the c
command level.
wing configur
able 4-16 Setting the command level fter a user logging in from a user
terface
Operation Command
Set command level used after a user logging in from a
user interface
user privilege level
level
Restore the d
logging in from
efault command level used after a user
a user interface
undo user privilege
level