Installation manual

Operation Manual - System Management
Quidway S3000-EI Series Ethernet Switches Chapter 5 SNMP Configuration
Huawei Technologies Proprietary
5-8
Table 5-14 Set the size of SNMP packet sent/received by an agent
Operation Command
Set the size of SNMP packet
sent/received by an agent
snmp-agent packet max-size byte-count
Restore the default size of SNMP
packet sent/received by an agent
undo snmp-agent packet max-size
The agent can receive/send the SNMP packets of the sizes ranging from 484 to 17940,
measured in bytes. By default, the size of SNMP packet is 1500 bytes.
5.3.14 Disable SNMP Agent
To disable SNMP Agent, please Perform the following configuration in system view.
Table 5-15 Disable snmp agent
Operation Command
Disable snmp agent undo snmp-agent
If user disable NMP Agent, it will be enabled whatever snmp-agent command is
configured thereafter.
5.4 Display and Debug SNMP
After the above configuration, execute display command in any view to display the
running of the SNMP configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug SNMP configuration.
Table 5-16 Display and debug SNMP
Operation Command
Display the statistics information
about SNMP packets
display snmp-agent statistics
Display the engine ID of the active
device
display snmp-agent { local-engineid |
remote-engineid }
Display the group name, the security
mode, the states for all types of views,
and the storage mode of each group
of the switch.
display snmp-agent group
[ group-name ]
Display the names of all users in the
group user table
display snmp-agent usm-user
[ engineid engineid ] [ group groupname ]
[ username username ]
Display the current community name
display snmp-agent community [ read |
write ]