Installation manual

Operation Manual - System Management
Quidway S3000-EI Series Ethernet Switches Chapter 4 System Maintenance and Debugging
Huawei Technologies Proprietary
4-12
Table 4-19 Turn on/off the information synchronization switch in Fabric
Device Configuration Default value Configuration description
Enable
info-center
By default, info-center is
enabled.
Other configurations are
valid only if the info-center
is enabled.
Switch
Set the
information
output
direction to
SNMP
By default, switches of
master log in Fabric,
debugging and trap
information
synchronization are
turned on, so as log and
strap information
synchronization switches
in other switches.
This configuration can keep
log information, debugging
information and trap
information in Fabric in
every switch synchronized.
4.5.3 Sending the Configuration Information to Loghost
To send configuration information to loghost, follow the steps below:
1) Enabling info-center
Perform the following operation in system view.
Table 4-20 Enable/disable info-center
Operation Command
Enable info-center info-center enable
Disable info-center undo info-center enable
 Note:
Info-center is enabled by default. After info-center is enabled, system performances are
affected when the system processes much information because of information
classification and outputting.
2) Configuring to output information to loghost
Perform the following operation in system view.
Table 4-21 Configuring to output information to loghost
Operation Command
Output information to loghost
info-center loghost host-ip-addr [ channel
{ channel-number | channel-name } ] [ facility
local-number ] [ language { chinese | english } ]