Installation manual

Operation Manual - Getting Started
Quidway S3000-EI Series Ethernet Switches Chapter 4 Use
r Interface Configuration
Huawei Technologies Proprietary
4-1
C
4.1 User Interface Overview
User in n is another way provided witch to configure and
manage the port data.
S3000-EI Series Ethernet Switc onfiguration methods:
z the Con
z Local and remote configuration thro H on Ethernet port
z Remote configuration throu
A mention two types of user
in
z
UX user interface is used to log in the switch via the Console port. A switch can only
have one AUX user interface.
VTY user interface is used to telnet the switch. A switch can have up to five VTY user
 Note:
hapter 4 User Interface Configuration
terface configuratio by the s
hes support the following c
Local configuration via sole port
ugh Telnet or SS
gh dial with modem via the Console port.
ccording to the above- ed configuration methods, there are
terfaces:
AUX user interface
A
z VTY user interface
interface.
For Quidw s switches, AUX port and Cons the same one. There is
only the type of AUX user
ay serie ole port are
interface.
User interface is numbered in the following two ways: absolute number and relative
n
1) Absolute number, following the rules below.
z ated as user interface
z r AUX user interface. The absolute number of the first VTY is
incremented by 1 tha
2 presented by “+ number” assigned to each type of user
interface. It follows the rules below:
z Number of AUX user interface: AUX 0.
z Number of VTY: The first VTY interface is designated as VTY 0, the second one is
designated as VTY 1, and so on.
umber.
AUX user interface is
0.
numbered as the first interface design
VTY is numbered afte
n the AUX user interface number.
) Relative number, re