Installation manual

Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches
Chapter 2 AAA and RADIUS Protocol
Configuration
Huawei Technologies Proprietary
2-15
erval in minutes. The
value shall be a multiple of 3.
r. The
smaller the value is, the erformances of NAS and RA uired.
W than 1000, ggest a
larg value to the number of
u
able 2-18 Recommended ratio of minutes to number of users
The parameter minutes specifies the real-time accounting int
The value of minutes is related to the performance of NAS and RADIUS serve
higher the p DIUS are req
hen there are a large amount of users (more inclusive), we su
er value. The following table recommends the ratio of minute
sers.
T
Number of users Real-time accounting interval (minute)
1 to 99 3
100 to 499 6
500 to 999 12
≥1000 ≥15
By default, minute is set to 12 minutes.
2.3.8 Sett
be Respo
timer. If the RADIUS
server has not received the real-time accounting packet from NAS for long, it will
, it is necessary to
disconnect the user a nd on RADIUS server synch n some
u u um times of
real t
h fro erver for some
pecified times.
ccounting
request failing to be responded
ing Maximum Times of Real-time Accounting Request Failing to
nded
RADIUS server usually checks if a user is online with timeout
consider that there is device failure and stop accounting. Accordingly
t NAS end a ronously whe
npredictable failure exists. Quidway Series Switches s
-time accounting request failing to be responded. NAS will disconne
pport to set maxim
ct the user if i
as not received real-time accounting response m RADIUS s
s
You can use the following command to set the maximum times of real-time a
Perform the following configurations in RADIUS scheme view.
Table 2-19 Setting maximum times of real-time accounting request failing to be
responded
Operation Command
Set maximum times of real-time accounting request
failing to be responded
retry realtim
retry-tim
e-accounting
es
Restore the maximum times to the default value
undo retry
realtime-accounting