Installation manual

Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches
Chapter 2 AAA and RADIUS Protocol
Configuration
Huawei Technologies Proprietary
2-5
z Perform the following configurations in ISP domain view.
Table 2-2 Configuring relevant attributes of ISP domain
Operation Command
Specify the adopted RADIUS scheme
radius-scheme radius-scheme-name
Restore the adopted RADIUS scheme to
the default RADIUS scheme
undo radius-scheme
Specify the ISP domain state to be used state { active | block }
Set a limit to the amount of supplicants
access-limit { disable | enable
max-user
-number }
Restore the limit to the default setting
undo ac
cess-limit
Set the idle idle-cut { disable | enable minute flow }
By default, af sed RADIUS scheme is the default one
n r nfiguring RADIUS
section of this chapter) activ e amount of
sup sabled
2.2.3 Enabling/Disabling the Messenger Alert
Messenger alert function allows the clients to inform the online users about their
maining online time through message alert dialog box.
wing command to enable this function and to configure
the remaining-online-time threshold (the limit argument) and the alert message
z If the threshold is reached, the switch sends messages containing the user’s
e updated remaining online time through a
Perf
Tabl
ter an ISP domain is created, the u
amed “system” (for relevant parameter configu
ation, refer to the Co
.,the state of domain is
plicants ,and the idle-cut function is di
e , there is no limit to th
.
re
The implementation of this function is as follows:
z On the switch, use the follo
interval.
remaining online time to the client at the interval you configured.
z The client keeps the user informed of th
dialog box.
orm the following configuration in ISP domain view.
e 2-3 Enabling/disabling message alert
Operation Command
Enable messenger alert and configure
remaining-online-time threshold and
interval at which the alert message is
messenger time enable limit interval
the
the
sent
Dis lert
messenger time disable
able messenger a