Installation manual

Operation Manual - Security
Quidway S3000-EI Series Ethernet Switches Chapter 1
802.1x Configuration
Huawei Technologies Proprietary
1-15
Table 1-17 Enabling/disabling a quiet-period timer
Operation Command
Enable a quiet-period timer
dot1x quiet-period
Disable a quiet-period timer
undo dot1x quiet-p
eriod
By default, quiet-period timer is disabled.
1.3 Displaying and Debugging 802.1x
e effect of the configuration. Execute
After the above configuration, execute display command in any view to display the
running of the VLAN configuration, and to verify th
reset command in user view to reset 802.1x statistics. Execute debugging command
in user view to debug 802.1x.
Table 1-18 Displaying and debugging 802.1x
Operation Command
Display the configuration, running and
statistics information of 802.1x
display dot1x [ sessions | statistics ]
[ interface interface-list ]
Reset the 802.1x statistics information
reset dot1x
interface-li
statistics [ interface
st ]
Enable the error/event/packet/all
debugging of 802.1x
debugging dot1x { error | event |
packet | all }
Disable the error/event/packet/all
debugging of 802.1x.
undo debugging dot1x { error | event |
packet | all }
1.4 802
I.
As shown in th workstation of a us ted to the port
E
T enable 802 thenticate the
supplicants so as to control their access to the Internet. The access control mode is
onfigured as based on the MAC address
ain huawei163.net, which can contain up to
30 users. RADIUS authentication is performed first. If there is no response from the
RADIUS server, local authentication will be performed. For accounting, if the RADIUS
server fails to account, the user will be disconnected. In addition, when the user is
.1x Configuration Example
Networking requirements
e following figure, the er is connec
thernet 0/1 of the Switch.
he switch administrator will .1x on all the ports to au
c
All the supplicants belong to the default dom