Installation manual

Operation Manual - STP
Quidway S3000-EI Series Ethernet Switches Chapter 1
MSTP Region-configuration
Huawei Technologies Proprietary
1-27
1.2.16 Ena
Y le MSTP on a port. You may
d ee
c operation and save the CPU
r h.
M
I. Configure in system view
Perform the f
T ble/Disable MSTP on a port
ble/Disable MSTP on a Port
ou can use the following command to enable/disab
isable MSTP on some Ethernet ports of a switch to
spare them from spanning tr
alculation. This is a measure to flexibly control MSTP
esources of the switc
STP can be enabled/disabled on a port through the following ways.
ollowing configuration in system view.
able 1-24 Ena
Operation Command
Enable MSTP on a port.
stp interface interface-list enable
Disable MSTP on a port.
stp interface interface-list disable
Restore the default MSTP state on the port.
undo
stp interface-list
. Configure in Ethernet port view
Perform the following configuration in Ethernet port view.
Table 1
II
-25 Enable/Disable MSTP on a port
Operation Command
Enable MSTP on a port.
stp enable
Disable MSTP on a port.
stp disable
Restore the default MSTP state on the port.
undo stp
You can enable/disable MSTP on a port with either of the above-mentioned measures.
fer to the Command Manual.
Note that redundant route may be generated after MSTP is disabled.
device.
1.3 Display and Debug MSTP
After the above confi cute display command in an play the
running of the MSTP configuration, and to verify the effect of the configuration. Execute
r w to clear the statistics odule. Execute
d ebug the MSTP m
For more about the commands, re
By default, MSTP is enabled on all the ports after it is enabled on the
guration, exe y view to dis
eset command in user vie of MSTP m
ebugging command in user view to d odule