Installation manual

Operation Manual - STP
Quidway S3000-EI Series Ethernet Switches Chapter 1
MSTP Region-configuration
Huawei Technologies Proprietary
1-11
ning tree instance 0. CIST is span
figure the MST Region for a Switch 1.2.1 Con
Which MST region a switch belongs to is determined with the configurations of the
e, and MSTP revision level. You can perform the
g configurations to put a switch into an MST region.
Follow the procedure listed in the table below and perform these configurations from
I. Enter MST region view
region name, VLAN mapping tabl
followin
system view.
Perform the following configuration in system view.
Table 1-1 Enter MST region view
Operation Command
Enter MST region view (from system view)
stp region-configuration
Restore the default settings of MST region
undo stp region-configuration
II. Configure the MST Region
Perform the following configuration in MST region view.
T tch
able 1-2 Configure the MST region for a swi
Operation Command
Configure MST region name
region-name name
Restore the default MST region name
undo region-name
Configure VLAN mapping table
instance instance-id vlan
vlan-list
Restore the default VLAN mapping table
undo instance
Configure the MSTP revision level of MST region
revision-level level
Restore the MSTP re f MST region
undo re
vision level o
vision-level
A anning tree hich the
Inst s 1 through 16 are MST
above config ch is put into a sp T region. Note that
tw n only if they ured with the
n MST region can contain up to 17 sp instances, among w
ance 0 is IST and the Instance
urations, the current swit
Is. Upon the completion of the
ecified MS
o switches belong to the same MST regio have been config