Installation manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches Chapter 2
HGMP V2 Configuration
Huawei Technologies Proprietary
2-19
II
Ethernet1/1 carrying VLAN2 at 163.172.55.1. The entire cluster uses the same FTP
server and TFTP server at 63.172.55.1 and the NM station and log host at 69.172.55.4.
. Networking diagram
Administrator
device
Member device MAC
address 00e0.fc01.0011
logging host
Cluster
SNMP host/
Network
FTP server/TFTP
E0
E1/1
/1
E1/1
69.172.55.4
ddress
2.55.1
Member device MAC
address 00e0.fc01.0012
III. Configuration procedure
) Configure the administrator device
ce and port Ethernet0/1 and Ethernet0/2.
[Quidway] ndp enable
[Quidway-Ethernet0/1] interface ethernet 0/2
# Set to hold ND n for 200 seconds.
[
#
[Quidway] ndp timer hello 70
# E
Quidway] interface ethernet 0/1
[Quidway-Ethernet0/1] ntdp enable
[Quidway-Ethernet0/1] interface ethernet 0/2
[Quidway-Ethernet0/2] ntdp enable
# Configure to collect topology information within 2 hops.
[Quidway] ntdp hop 2
server
63.172.55.1
VLAN interface 2
/1 E0/2
E1
IP a
163.17
Figure 2-3 HGMP networking
1
# Enable global NDP on the devi
[Quidway] interface ethernet 0/1
[Quidway-Ethernet0/1] ndp enable
[Quidway-Ethernet0/2] ndp enable
P informatio
Quidway] ndp timer aging 200
Configure to sends NDP packet every 70 seconds.
Enable NTDP on the device and the port thernet0/1 and Ethernet0/2.
[Quidway] ntdp enable
[