Installation manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches Chapter 2
HGMP V2 Configuration
Huawei Technologies Proprietary
2-17
hen using the reboot member command, you can decide to delete the configuration
2.4.11 Co ent and Log
Hosts
anagement and log
ilarly, all the trap packets are output to the cluster
W
file or not with the eraseflash parameter.
nfigure the Cluster Server and Network Managem
After a cluster is set up, you can configure the server and network m
hosts on the administrator device for the entire cluster.
A member device accesses the configured server through the administrator device.
The cluster members output all log information to the configured log host in the end. A
member outputs and sends the log information to the administrator device directly. The
administrator device translates the log information addresses and sends the log
packets to the cluster log host. Sim
NM host.
You can use the following commands to configure the cluster server and network
management and log hosts.
Perform the following configuration in cluster view.
Table 2-22 Configure FTP /TFTP Servers and Logging/SNMP Hosts for a Cluster
Operation Command
Configure FTP server for the whole cluster.
ftp-server ip-address
Remove the FTP server from the cluster.
undo ftp-server
Configure TFTP server for the whole cluster.
tftp-server ip
-address
Remove the TFTP server from the cluster.
undo tftp-server
Configure the logging host for the whole cluster. logging-host ip-address
Remove the logging host from the whole cluster.
undo logging-hos
t
Configure the SNMP host for the whole cluster. snm p-host ip-address
Remove the SNMP host from the whole cluster.
undo snmp-host
Note that the above command can only be executed on the administrator device.
2.4.12 Mem
A member device in a cluster can be managed through the administrator device. You
this,
Authorization is required when you want to configure a switch on the administrator
device. Upon passing the member device authorization, the configuration is allowed. If
ber Accessing
can configure a specified member device on administrator device .In order to do
you should enter the specified member device view on the administrator device; after
configuration, you can exit the view.