Installation manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches Chapter 2
HGMP V2 Configuration
Huawei Technologies Proprietary
2-13
Table 2-14 enter cluster view
Operation Command
enter cluster view.
cluster
2.4.4 Configure Clus
B , you are su ure a private IP address pool.
When a Candidate device is added, the administrator device will dynamically assign a
p an be used f e the cluster. In this way,
ou can use the administrator device to manage and maintain the member devices.
ter IP Address Pool
efore setting up a cluster pposed to config
rivate IP address, which c or communication insid
y
Perform the following configuration in cluster view.
Table 2-15 Configure cluster IP address pool
Operation Command
Configure cluster IP address pool.
ip-pool administrator-ip-address
{ ip-mask | ip-mask-length}
Restore the default IP address pool of
undo ip-pool
the cluster.
Before setting up a cluster, the user should configure a private IP address pool for the
tion can only be performed on administrator device, and
must be configured before the cluster is build. The IP address pool of an existing
cluster cannot b
2.4.5 Name Administrator device and Cluster
Every cluster has a name.
ster view.
member devices of the cluster.
Note that, the above configura
e modified.
Perform the following configuration in clu
Table 2-16 Name the administrator device and cluster.
Operation Command
Name Administrator device and Cluster.
build name
Remove all the member devices from the cluster and
device.
undo build
configure the administrator device as a Candidate
This command can only be used on an administrator device. When executed on an
administrator device to configure a different cluster name, the command can be used to
rename the cluster.