Installation manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches Chapter 2
HGMP V2 Configuration
Huawei Technologies Proprietary
2-6
2.2.4 Set
specifies how long the adjacent node can keep the local node
acent device knows the holdtime from the received NDP packet
NDP Holdtime
The NDP holdtime
information. The adj
and will discard the packet when it expires.
Perform the following configuration in System view.
Table 2-3 Set NDP Holdtime
Operation Command
Set NDP Holdtime
ndp timer aging aging-in-secs
Restore the de oldtime.
undo ndp timer aging
fault NDP h
N o be lo (described in the
ion). Otherwise, NDP information table will be unstable.
By default, NDP is hold for up to 180 seconds.
2.2.5 Set
ll be updated frequently to guarantee
the timely updating for local information. You can use the following command to decide
DP information will be updated.
ote that NDP holdtime is supposed t nger than the NDP timer
following sect
NDP Timer
The NDP information of the adjacent nodes sha
how often the N
Perform the following configuration in System view.
Table 2-4 Set NDP timer
Operation Command
Set NDP timer
ndp
timer hello seconds
Set the NDP timer back to the default setting
undo ndp timer hello
N er is supposed to be shorter tha bed in the
previous section). Otherwise, NDP information tabl
By default, NDP is transmitted every 60 seconds.
2.2.6 Display
to display the
effect of the configuration. Execute
reset command in user view to clear the statistics of NDP module. Execute debugging
command in user view to debug the NDP module.
ote that NDP tim n the NDP holdtime (descri
e will be unstable.
and Debug NDP
After the above configuration, execute display command in any view
running of the NDP configuration, and to verify the