Installation manual

Operation Manual - Integrated Management
Quidway S3000-EI Series Ethernet Switches Chapter 1
Stack Function Configuration
Huawei Technologies Proprietary
1-2
Table 1-1 Configure IP address pool for the stack
Operation Command
Configure IP address range for a stack
stacking ip-pool from-ip-address
ip-address-number [ ip-mask ]
Restore to the default IP address range
undo stacking ip-pool
Before setting up a stack, the user should configure a public IP address pool for the
slave switch of the stack.
Please note that the above configurations can only be performed on the non-stack
switches. After a stack is enabled, the user is prevented from modifying the IP address
pool.
1.2.2 Enable/Disable a Stack
When the user enables a stack with the following command, the system will
stem view.
automatically add the switches, connected to the main switch via stack ports, to the
stack. After a stack has been enabled, if the stack port is disconnected, slave switch will
exit the stack automatically.
Perform the following configuration in sy
Table 1-2 Enable/Disable a stack
Operation Command
Enable a stack
stacking ena
ble
Disable a stack
undo stacking enable
lease note that you can only operate on the main switch to disable a stack.
1.2.3 Swi
ew to a slave
switch view to change the configuration.
Table 1-3 Switch to a slave switch view to perform the configuration
P
tch to a Slave Switch view to Perform the Configuration
The following command can be used to switch from the main switch vi
Please perform the following configurations in user view.
Operation Command
Switch to a slave switch view to perform
stacking num
the configuration
Please note that the above command can r switching from the main
witch view to a slave switch view and the user level remains the same after switching.
To switch from a slave switch view back to a main switch view, input quit.
only be used fo
s