Installation manual

Operation Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches Chapter 3 Logon User ACL Co
ntrol Configuration
Huawei Technologies Proprietary
3-2
sic ACL Table 3-1 Defining the ba
Operation Command
Enter basic ACL view(from
system view)
acl
basic
{ number acl-number | name acl-name
} [ match-order { config | auto } ]
add a sub-item to the ACL(from
basic ACL view)
rule
sour
[ tim
[ rule-id ] { permit | deny } [ source
ce-addr wildcard | any ] [ fragment ]
e-range name ]
delete a sub-item from the
ACL(from basic ACL view) [ tim
undo rule rule-id [ source ] [ fragment ]
e-range ]
Delete one ACL or all the
ACL(from system view) acl-
undo acl { number acl-number | name
name | all }
In the defining process, you can configure several rules for an ACL, using the rule
command repeatedly.
3.2.2 Calling ACL to Control TELNET Users
o control TELNET users with ACL, you can call the defined ACL in user-interface view.
You can use the following command to call an ACL.
ollowing configuration in corresponding view.
alling ACL to control TELNET users
T
Perform the f
Table 3-2 C
Operation Command
Enter user-interface view(from
s
user-interface [ type ] first-number
sy tem view) [ last-number ]
Call an ACL(from user-interface
view)
acl acl-number { inbound | outbo
und }
No
For detailed description of the command, refer to the Command Manual.
 te:
Only the numbered ACL can be called for TELNET user control.
3.2.3 Con
I. Networking requirements
TELNET user from 10.110.100.52 and 10.110.100.46 access switch.
figuration Example
Only permit