Installation manual

Operation Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches Chapter 2
QoS Configuration
Huawei Technologies Proprietary
2-12
references of those not match the rules to 4. And It is required to limit the traffic from
II. Networking diagram
p
other department to the server to no more than 20M.
Pay query server
129.110.1.2
Switch
#1
#2
#4
#3
Connected to a router
Pay query server
129.110.1.2
Switch
E0/1
Connected to a router
Pay query server
129.110.1.2
Switch
#1
#2
#4
#3
Connected to a router
Pay query server
129.110.1.2
Switch
#1
#2
#4
#3
Connected to a router
Pay query server
129.110.1.2
Switch
E0/1
Connected to a router
Figure 2-2 Access c
III. Configuration procedure

ontrol configuration example
Note:
In to QoS/ACL configurations
a
the following config
re listed.
urations, only the commands related
1) Define the traffic accessing the payment query server
# Enter the named advanced ACL view
[Quidway] acl name traffic-of-payserver advanced match-order config
, identified as traffic-of-payserver.
2) Define the limit to the traffic-of-payserver
# Limit the average speed of the traffic-of-payserver to 20M, sets the IP precedence of
the packets exc itted average rate in the traff
[Quidway-Ethernet0/1] traffic-limit inbound ip-group traffic-of-payserver 20
exceed remark-dscp 4
#
[
# Define advanced ACL traffic-of-payserver.
[Quidway-acl-adv-traffic-of-payserver] rule 1 permit ip source 129.110.1.2
0.0.0.0 destination any
eeding comm ic to 4.
Limit the sending rate of Ethernet0/1 as 20M.
Quidway-Ethernet0/1] line-rate 20