Installation manual

Operation Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches Chapter 2
QoS Configuration
Huawei Technologies Proprietary
2-4
mmon WRR, the Delay bounded WRR also guarantee the packets
in the highest-priority queue to leave the queue before the configured delay.
2.1.9 Traf
ut by copying the specified data packets to the
port for network diagnosis and troubleshooting.
unt and
z Configuring trust packet priority
lter
z Traffic policing
S tasks, you have to define the corresponding ACL.
2.2.1 Sett
Perform the following configuration in Ethernet port view.
Comparing to the co
fic Mirroring
The traffic mirroring function is carried o
monitoring
2.1.10 Traffic Counting
With the flow-based traffic counting, you can request a traffic count to co
analyze the packets.
2.2 Configuring QoS
QoS configuration includes:
z Setting port priority
z Packet fi
z Redirection configuration
z Priority tag
z Queue scheduling
z Traffic mirroring
z Traffic statistics
Before configure the about Qo
Packet filter function can be realized by activate the ACL.
ing Port Priority
You can use the following command to set the port priority. The switch will tag the
packet using the VLAN the received port belong to if the packet has no VLAN tag.
Meanwhile the system uses the port priority as the packet the 802.1p priority when tag
the packet. If the packet has VLAN tag, the system will not re-tag the packet.
Table 2-1 Setting port priority
Operation Command
Set the port priority
priority priority-level
Restore the default port priority
undo priority