Installation manual

Operation Manual - QoS/ACL
Quidway S3000-EI Series Ethernet Switches Chapter 2
QoS Configuration
Huawei Technologies Proprietary
2-2
standards are encapsulated in the header of the packets. The packet content is seldom
used as the classification standard.
2.1.3 Packet Filter
fic. For example, the operation “deny” discards the traffic that
traffic classification rule, while allowing other traffic to pass through.
With the complex traffic classification rules, Ethernet Switches enable the filtering of
g to the classification rule;
2.1.4 Traf
that it can make a better use of the
2.1.5 Port
2.1.6 Red
2.1.7 Traffic Priority
The Ethernet Switch can deliver priority tag service for some special packets. The tags
ed in different QoS
modules.
2.1.8 Queue Scheduling
Packet filter is to filter traf
is matched with a
various information carried in Layer 2 traffic to discards the useless, unreliable or
doubtful traffic, thereby enhancing the network security.
The two key steps of realizing the frame filtering are as follows.
Step 1: Classify the ingress traffic accordin
Step 2: Filter the classified traffic, i.e. the “deny” operation, the default ACL operation.
fic Policing
In order to deliver better service with the limited network resources, QoS monitors the
traffic of the specific user on the ingress, so
assigned resource.
traffic Limit
The port traffic limit is the port-based traffic limit used for limiting the general speed of
packet output on the port.
irection
You can specify a new port to forward the packets according to your requirements on
the QoS policy.
include TOS, DSCP and 802.1p, etc., which can be used and defin
When congestion occurs, several packets will compete for the resources. Three kinds
of queue scheduling algorithms are used to overcome the problem. These three kinds
of queue scheduling algorithms are Strict-Priority Queue (SP), Weighted Round Robin
(WRR) and Delay bounded WRR.
1) SP