Product Manual

Virena Router Connection Verification Performing Tests in Surveillance Mode
Go to the Main Menu and select Run Test.
Enter (User ID, Patient ID and Order #) if required, then press Start Test.
Patient Demographics screen (Figure 22).
Note: Fields #1-4 allow for additional demographics data not currently
defined in Sofia.
Enter numeric value for Age (select appropriate units of Years, Months,
or Weeks) by using the Right arrow.
Press the Down arrow and select Patient Status (select In-patient, Out-
patient, or leave blank) by using the Right arrow. Then press Start Test.
Send Results to SURV Receiver
When Send Results to SURV Receiver is selected, the following options
will be displayed on the screen:
◗ Send Unsent Results
◗ Send Last Result
◗ Send All Results
◗ Send All Results
◗ Test SURV Connection
When selecting to send results, you will see Sending to SURV.
If data was sent successfully, the screen will display Data were
transmitted.
Figure 22
Select Test SURV Connection in the Send Results to SURV Receiver
menu to verify router connection.
If connection is established, screen displays “The Analyzer can be
connected to SURV.”
Then press OK to return to the Main Menu; Sofia is now ready to be run
in the Surveillance Mode.
If connection is not established, screen displays “The Analyzer cannot
be connected to SURV.”
Then press OK to return to the Main Menu. Review Sofia and Virena
Router Connection Installation and Set Network Configuration on
page 44 to confirm all settings and connections.
If unsuccessful in configuring Router or network connections, contact
Quidel Technical Support. For additional contact information (page 3).
Review Data
Main Menu
Send Results
Send Unsent
Results
Send All
Results
Test SURV
Connection
Send Last
Results
Send Results
to LIS
Send Results to
SURV Receiver
Installation and Setup
Installation and Setup46
47