Product Manual

◗ SD Card – Proper insertion should follow the diagram label on
Sofia. The SD Card should be inserted with the copper contact
points facing away from the power switch with the notched corner
facing down as shown (Figure 3).
Sofia will display the Power On progress screen and complete a Power
On Self-Test. The Barcode Scanner will chirp upon powering up. Once the
Power On is complete, Sofia will display the Start Test screen (Figure 6)
and Sofia is ready for use.
Figure 6
Figure 4
Loading Paper
Load paper into the integrated printer of Sofia (Figure 4).
◗ Lift black handle to remove paper cover.
◗ Place paper in the paper holder with the paper tail coming from
under the roll towards the operator.
◗ Holding the paper tail towards the operator, replace the paper
cover and snap in place.
Note: The paper does not need to be fed through the roller.
Power Up
Turn Sofia on using the power switch located on the rear panel (Figure 5).
Hold the toggle switch down for 1-2 seconds until the screen
illuminates.
Figure 3
Figure 5
Power Switch
DC Power
Cord into
Power Port
RJ45
Barcode Scanner
into PS2 Port
SD Card Slot
Installation and Setup
Installation and Setup16
17