Wall Installation Instructions

2018_0202_QS_INST
9) Adhere the plank to the wall leaving a 3/16" gap (A) from the corners of the wall and a 1"
gap (B) at bottom. Drive brad nails 1/2" from the top and bottom of each plank to secure
to wall. Place nails where the trim will cover.
10) Continue with the installation for each subsequent plank by first applying silicone
adhesive to the back side of the plank in an “S” pattern. Then angle the groove over the
tongue of the previous plank and wiggle into place. Tighten joints as needed with a
tapping block or pull bar. Finally, drive brad nails 1/2" from the top and bottom of each
plank to secure to wall. Place nails where the trim will cover. Be sure to drive the brad
nails into a stud whenever possible. (Figure 4)
11) Finish wainscot accent to ending wall. (Figure 5)
12) Install trim (chair rail) over the top edge. Install quarter round in the corners. Finish by
installing the baseboard of your choice. (Figure 6)