Owner`s manual

Quicksilver
44
Fold Bunk Ends
With the tent inside the box, you can now go
to one of the bunk ends (it doesn’t matter
which one rst) and unhook the support poles
from the bottom of the bunk. Then, with a
partner, carefully lift bunk base up towards
vertical, keeping your hands on it at all times,
then slowly lowering it toward the center of
the camper box. Set this bunk base on top
of the camper box, double checking that the
tent is not sticking out anywhere, then move
to the other bunk and repeat the process.
Once both bunks are in the closed position,
undo the support poles from the unit and
store them in the black PVC tube located
under the camper.
Hint: Put the four support poles back to back
with their hardware/clips facing out (not
towards each other). This will allow the four
poles to quickly and easily slide into the tube.
Replace Tonneau Cover
Unfasten the Velcro that holds the tonneau
cover in its storage position on the end of the
camper and begin to roll it back into place.
A helpful hint here is to do the rst snap on
either side of the camper before you attempt
to stretch the entire tonneau over the camper,
snapping it into place as you go along.
Release Stabilizer Jacks
To disengage the jacks, crank the tongue
jack down to a lower position than the rear.
Collapse the stabilizer jacks and fold them
back into travel position. Crank tongue jack
up and release front jacks.
Retract Step Into Travel Position
Hitch Unit
Hitch camper securely to your vehicle (see
hitching instructions) and you’re ready to go!