Owner`s manual

43
www.LivinLite.com
Closing The Unit:
Zip Up Windows
Be sure to zip all windows and shades closed
prior to closing the unit. Closing the unit is
much easier without extra material causing
unnecessary bulk.
Break Down the Dinette
Remove the dinette table and fold the legs into
their storage position. Set the table on the
dinette seat base supports. Put the cushions
in the bed position across the dinette table
and bases.
Lower Swing Galley
After detaching the water and drain lines, use
the handle to lift and swing the top section of
the galley to the oor.
I
CAUTION
You must remember to remove the center
support pole from between the center
bimini poles before folding the tent down.
Failure to do this will likely cause damage
to your camper.
Close Door
Be sure to close the door rmly and zip the
tent door closed.
Lowering the Tent
Prior to lowering your tent, be sure that both the
galley and the dinette is in the down, or travel
position. When lowering your tent, always start
by taking out the center support bar(s).
Once that is done, you will be putting the
galley side of the tent down rst (8’ and
10’ models). Begin by detaching the snaps,
Velcro and bungees at that end of the tent.
Hint: When folding your tent, the opposite
side will want to close at the same time. Leave
one snap fastened on one bunk end to hold
the second side upright while you collapse
the rst set of poles. When both sides are
collapsed you will notice a lot of tent material
hanging over the sides. Simply fold it over
the top of the biminis, inside the box and
push down.
Next, be sure to push
the tent sides up and
over the corner bend
in the bimini poles.
This will ensure that
the tent does not
catch up or become
bound against the
sides of the box when lowered.
IMPORTANT! - Be sure to pull the tent away
from the bimini poles so that it does not get
stuck between the biminis as it is going back
into the box!
Next, while lowering that end of the camper,
take any excess tent and pull it away from the
camper and the biminis on the sides. Once
that half of the tent has been lowered into the
camper box, repeat the same process with
the end opposite the galley.
Once both sides of the tent have been lowed
into the box, and you are certain that the tent
is not bound between the bimini poles, take
the excess tent, which should be hanging
out over the sides, and ip it over into the
camper box. Double check that the tent is
entirely inside the camper box and that it is
not hanging out any where.
Hint: You will need to
push the bimini poles
down and inside the
unit. Don’t be afraid
to move the biminis
around a little to
accomplish this.