Instructions / Assembly

The technical content of this literature is eective 5/31/12 and supersedes all previous information.Pub. No. CD-Full Line 5/12
clarkdietrich.com
80
WEEP And SILL SCREEdS
F.H.A.7 FOUNDATION WEEP SCREED
F.H.A.7 foundation weep screed
protects the stop edges of stucco
and exterior insulated finish
system materials at the sill plate.
Commonly referred to as F.H.A.
screed, it meets all pertinent
F.H.A. requirements as part of
a drainage system for exterior
stucco applications. Meets IBC
requirement for foundation screeds.
Product code
Size
Grounds
(in)
Depth
(in)
Length
(ft)
FHA7
7/8 3-1/2 10
1-3/8 3-1/2 10
Also available without bonding holes and in 28 gauge (FHAE) for non-code work.
7/8" SILL SCREED
7/8" sill screed is a similar profile
to the F.H.A.7 foundation weep
screed except the bottom flange
has been cut back to allow trowel
access for cleaning excess material
and trimming of the vapor barrier.
It offers impact and splash
protection, and meets all other
applicable codes with respect to
3-1/2" nailing flange, 26 gauge
galvanized steel and 7/8" ground.
Product code
Size
Grounds
(in)
Depth
(in)
Length
(ft)
SI36 7/8 5-1/2 10
13/8"JWEEP WITH 2" NAILING FLANGE AND WEEP HOLE
ClarkDietrich 1-3/8" J-weep low-
back is commonly used as a stop
around door and window openings
or in areas where stucco or E.I.F.S.
terminations abut dissimilar wall
types. Nail, screw or staple-attach
to the frame or sheathing, then
foam insulation, cement board or
metal lath can be installed over it.
The protruding ridge of the metal
must extend beyond the plane of
overlaid materials.
Product code
Size
Weep
hole
Grounds
(in)
Depth
(in)
Length
(ft)
JCLB 1-3/8 2 10 No
JWLB 1-3/8 2 10 Yes
NOTE: Do not use as a foundation weep screed for three-coat stucco applications. It should
only be used on approved one-coat systems. Does not conform to code-required work if
used as a foundation weep.