Instructions / Assembly

70
VINYL BEADS AND TRIMS
The technical content of this literature is eective 5/31/12 and supersedes all previous information.Pub. No. CD-Full Line 5/12
clarkdietrich.com
VINYL 093 DRYWALL CONTROL JOINT
Vinyl 093 control joint is applied
between abutting gypsum panels
to relieve stresses of expansion
and contraction of drywall in large
ceiling and wall expanses over 30'.
Typically installed from door header
to ceiling, from floor to ceiling in
long partition runs, and from wall to
wall in large ceiling areas. Remove
plastic tape (protects 1/4" opening
x 7/16" deep reveal) after compound
is applied and finished.
Product
code
Size
Width (in)
Length (ft)
VCJT
3/32
10
Note: Where sound transmission is a consideration, an approved seal must be provided
behind the control joint.
BULLNOSE “J” BEAD
Vinyl Corp. bullnose “J” bead is
designed to cover the raw edges of
wallboard with a 3/4" radius bead.
The perforated flange accepts joint
compound or veneer plaster for a
flush finish.
Product
code
Board
thickness (in)
Size Pcs./Box
BJB50 1/2
1" perforated flanges,
3/4" back leg
50
BJB58 5/8 50
BULLNOSE “J” BEAD
Vinyl Corp. bullnose “J” bead for
surface application is designed to
be applied after the wallboard is
installed. Cover the raw edges of
wallboard with a 3/4" radius bead.
The perforated flange accepts joint
compound or veneer plaster for a
flush finish.
Product
code
Board
thickness (in)
Size
Pcs./Box
BJB50S 1/2
1” perforated flanges
50
BJB58S 5/8 50
Surface Application