MSDS

829350 - Quicksilver Quickleen Engine & Fuel System Cleaner
Issue Date: 03-Oct-2017
Page 2
Status: FINAL
_ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ _
SECTION 3: Composition/information on ingredients
Chemical Name
CASRN
Concentration¹
Petroleum distillates, hydrotreated light
64742-47-8
70-80
Naphtha, petroleum, hydrotreated heavy
64742-48-9
1-5
Paraffins, petroleum, normal C5-20
64771-72-8
1-5
Xylenes (o-, m-, p- isomers)
1330-20-7
1-5
Ethylbenzene
100-41-4
<1
¹ All concentrations are percent by weight unless ingredient is a gas. Gas concentrations are in percent by volume.
SECTION 4: First aid measures
Eye Contact: If irritation or redness develops from exposure, flush eyes with clean water. If symptoms persist, seek medical
attention.
Skin Contact: Remove contaminated shoes and clothing, and flush affected area(s) with large amounts of water. If skin surface is
damaged, apply a clean dressing and seek medical attention. If skin surface is not damaged, cleanse affected area(s) thoroughly by
washing with mild soap and water or a waterless hand cleaner. If irritation or redness develops, seek medical attention. Wash
contaminated clothing before reuse.
Inhalation: First aid is not normally required. If breathing difficulties develop, move victim away from source of exposure and into
fresh air in a position comfortable for breathing. Seek immediate medical attention.
Ingestion: Aspiration hazard: Do not induce vomiting or give anything by mouth because this material can enter the lungs and
cause severe lung damage. If victim is drowsy or unconscious and vomiting, place on the left side with the head down. If possible,
do not leave victim unattended and observe closely for adequacy of breathing. Seek medical attention.
Most important symptoms and effects, both acute and delayed: Prolonged or repeated contact may dry skin and cause
irritation. While significant vapor concentrations are not likely, high concentrations can cause minor respiratory irritation, headache,
drowsiness, dizziness, loss of coordination, disorientation and fatigue. Ingestion can cause irritation of the digestive tract, nausea,
diarrhea, and vomiting.
Notes to Physician: Acute aspirations of large amounts of oil-laden material may produce a serious aspiration pneumonia.
Patients who aspirate these oils should be followed for the development of long-term sequelae. Inhalation exposure to oil mists
below current workplace exposure limits is unlikely to cause pulmonary abnormalities.
SECTION 5: Firefighting measures
NFPA 704 Hazard Class
Health: 1 Flammability: 2 Instability: 0 0 (Minimal)
1 (Slight)
2 (Moderate)
3 (Serious)
4 (Severe)
Extinguishing Media: Dry chemical, carbon dioxide, or foam is recommended. Water spray is recommended to cool or protect
exposed materials or structures. Carbon dioxide can displace oxygen. Use caution when applying carbon dioxide in confined
spaces. Simultaneous use of foam and water on the same surface is to be avoided as water destroys the foam. Water may be
ineffective for extinguishment, unless used under favorable conditions by experienced fire fighters.
Specific hazards arising from the chemical
Unusual Fire & Explosion Hazards: Flammable. This material can be ignited by heat, sparks, flames, or other sources of
ignition (e.g., static electricity, pilot lights, mechanical/electrical equipment, and electronic devices such as cell phones,
computers, calculators, and pagers which have not been certified as intrinsically safe) Vapors may travel considerable
distances to a source of ignition where they can ignite, flash back, or explode. May create vapor/air explosion hazard indoors,
in confined spaces, outdoors, or in sewers. This product will float and can be reignited on surface water. Vapors are heavier
than air and can accumulate in low areas. If container is not properly cooled, it can rupture in the heat of a fire.