Owner`s manual

CHECK

OWNER S MANUAL

OBD2 CODE SCANNER

If the scan tool is not connected or no communication is established with

the vehicle yet, then refer to Reading Codes from 1 to 8 at Paragraph 3.2.

2). A warning message comes up asking for your confirmation.

Erase Codes

=======================

Erase trouble codes!

Are you sure?

YES <NO >

3). If you do not want to proceed with erasing the codes, press the

button

to exit. A message of

"command cancelled"

will show up.

4). If you do wish to proceed to erase the codes, then press the

button.

5). If the codes are cleared successfully. an

"ERASE DONE!"

confirmation

will show on the display. Press any button to return to previous menu.

6). If the codes are not cleared, then an

"ERASE FAILURE!"

”message will

appear. Press the

button to return to previous menu.

OBDII/EOBD Diag.

=======================

1) Read Codes

2) Erase Codes

10). If more than are DTC is found, use the

UP/DOWN

scroll buttons, as

necessary, until all the codes have been shown up.

Erasing Codes

1). If you decide to erase the DTCs, use the

UP/DWON

scroll buttons to

select

Erase Codes

from the

OBDII/EOBD Diag.

menu and press the

button.