Use and Care Guide

ManualsBrandsQuickloader ManualsChainsQL1500 1500 -lbs Break Strength, 500 -lbs Work Load Limit Retractable Ratchet Tie Down Strap

USE AND CARE

Use only as intended.!See Safety Measure document included

with product."

•

Ensure ratchet is in good working order prior to each use."

•

Check nylon webbing for wear, frays, and rips"

•

Check ratchet for cracked or bent parts."

•

Check entire tie-down for damage and proper working

operation."

•

Keep ratchet mechanism clean to avoid rust and ensure

smooth operation."

•

When not in use, keep ratchet in a dry area where it cannot

become damaged or inoperable."

SAFETY MEASURES!– use only as intended."

NOTE:!Quickloader/Wessel Industries LLC is not able to advise

on speciﬁc load securements as there are too many variables

and unknowns about each load for us to do so (eg the load

characteristics itself (weight and dimensions), equipment and

transportation conditions, linear and downward pressure,

bouncing etc.)"

It is important to follow Local Regulations for load securement,

including using appropriate straps/size and load ratings for your

load, as well as U.S. Department of Transportation, Federal

Motor Carrier Safety Administrations’s Cargo Securement

Rules!https://www.fmcsa.dot.gov/regulations/cargo-securement/

cargo-securement-rules."

Summary of content (4 pages)

PAGE 1
USE AND CARE Use only as intended. See Safety Measure document included with product. • • • • • • Ensure ratchet is in good working order prior to each use. Check nylon webbing for wear, frays, and rips Check ratchet for cracked or bent parts. Check entire tie-down for damage and proper working operation. Keep ratchet mechanism clean to avoid rust and ensure smooth operation. When not in use, keep ratchet in a dry area where it cannot become damaged or inoperable. SAFETY MEASURES – use only as intended.
PAGE 2
Ensure that there is a minimum of 2 and a maximum of 4 turns of webbing on the ratchet spindle. A bouncing load may reduce tension on the ratchet spindle causing the webbing around the spindle to loosen. Ensure the load is secured in a manner so that bouncing does not occur. Quickloader/Wessel Industries LLC is not responsible for the attachment or the installation. It neither guarantees, nor will it be liable for any damage resulting from its attachment or improper use.
PAGE 3
aids such as levers and bars as extensions are not to be used to increase the tension. The Quickloader’s rating (Load/Breakforce) should not be the only determining factor of securing the load. It is vital that the anchoring points and fittings be equal to or greater than the load being secured. Use your hand as a brake on the webbing spool during retraction to avoid the hook and webbing returning at a high speed. A visual inspection before and after each use is recommended.
PAGE 4
Do not to open the plastic spring box. Attempting to open the spring box may result in serious injuries. Any attempt to open will immediately void all Warranties and Liabilities. Quickloader is subject to normal wear and tear. The capacity stated on the label is the capacity for a new and unused product. Degradation of the stated capacity may occur after use. Please note: The driver is responsible for securing the cargo according to applicable laws, rules and regulations.