Instructions / Assembly

QuickJack™ Portable Car Jack 7 P/N 5900959 — Rev. J3 — Oct. 2019
• Floor surface must be dry, flat, and have a minimum compressive strength of 500 PSI.
• Avoid using an extension cord; they can overheat. If you must use an extension cord, make sure it
is No. 14 AWG minimum.
• Take care locating the electrical cable and Hydraulic Hoses; you do not want them driven over or
stepped on.
• Clear the area if a Vehicle is in danger of falling off the jack.
•
Make sure both Lock Bars are engaged before nearing an elevated Vehicle.
• Do not work under an elevated Vehicle unless properly rated Vehicle Jack Stands are used and
placed under the factory-approved Lifting Points.
Symbols
Following are the symbols used in this manual:
⚠ DANGER Calls attention to an immediate hazard that will result in death or severe injury.
⚠ WARNING Calls attention to a hazard or unsafe practice that could result in death or severe
personal injury.
⚠ CAUTION Calls attention to a hazard or unsafe practice that could result in minor personal
injury, product, or property damage.
Tip Calls attention to information that can help you use your QuickJack better.
Liability Information
BendPak assumes no liability for damages resulting from:
• Use of the equipment for purposes other than those described in this manual.
• Modifications to the equipment without prior, written permission from BendPak.
• Damage to the equipment from external influences.
• Incorrect operation of the equipment.