Instructions / Assembly

ManualsBrandsQuickJack ManualsAutomotiveBL-7000SLX 7,000 lbs. Capacity Portable Car Lift

Table Of Contents

QuickJack Manual
Table of Contents
Introduction
Shipping
Safety
- Important Safety Instructions
- QuickJack Safety Information
- Symbols
- Liability Information
Components
Accessories
- SUV and Light Truck Adapter Kit
- SLX Frame Extension Kit
- Motorcycle Lift Adapter Kit
- Ranger RML-1100 Motorcycle Jack
- JackPak
Specifications
Frequently Asked Questions
Setup Checklist
Setup
- Setup Safety Rules
- Tools
- Selecting a Site
- Unpacking
- Clearances
- QuickJack Assembly Kit
- Air and Hydraulic Cylinders
- Installing the Hydraulic Elbow Fittings
- Preparing the Short Hydraulic Hoses
- About Quick-Connect Fittings
- Routing the Short Hydraulic Hoses
- Preparing and Connecting the Long Hydraulic Hoses
- Pressurizing the Air Cylinders
- Find a Location for the Power Unit
- Installing the Hydraulic Fittings on the Power Unit
- Connect the Power Unit to a Power Source
  - Power Sources for VAC Power Units
    - 110 VAC Power Unit
    - 220/240 VAC Power Unit
  - Power Sources for 12 VDC Power Units
    - 12 VDC Power Unit
- Filling the Hydraulic Fluid Reservoir on the Power Unit
- Check the Breather Valve
- Connect the Hydraulic Hoses
- Bleeding the Hydraulic Cylinders
- Final Checklist Before Operation
- Test the QuickJack
- Leave the Manual with the Owner/Operator
Operation
- Safety
- About Lift Blocks
- Special QuickJack Warnings
- Positioning the Lift Blocks and Frames
- Raising the QuickJack Frames
- Lowering the Frames from the First Locking Position
- Lowering the Frames from the Top Locking Position
- Using the 12 VDC Power Unit
- Additional Operating Information
- Hydraulic System Warnings
Maintenance
- Lubrication Points
- About Outdoor Operation
Troubleshooting
- Frames at Full Height with No Load
- Vehicle with No Tires Fully Lowered
- Priming the Pump
Wiring Diagrams
- 12 VDC Wiring Diagram
- 208-230 VAC Wiring Diagram
Labels
Parts Sheets
Automotive Lift Institute (ALI) Store
Maintenance Log
CE Documentation

QuickJack™ Portable Car Jack 24 P/N 5900959 — Rev. J3 — Oct. 2019

Preparing and Connecting the Long Hydraulic Hoses

Your QuickJack comes with two Long Hydraulic Hoses:

• One end attaches to the Short Hydraulic Hose

• The other end attaches to the Power Unit

Both ends require the installation of a female Quick-Connect Fitting.

To prepare and connect your Long Hydraulic Hoses:

1. Locate both Long Hydraulic Hoses and remove their protective caps.

2. Wrap all four threaded ends with Thread Seal Tape.

Wrap the Thread Seal Tape in the same direction you will be turning the fittings.

3. Take all four female Quick-Connect Fittings from the QuickJack Assembly Kit.

4. Connect the female Quick-Connect Fittings to the male threaded connectors on both ends of both

Long Hydraulic Hoses; four connections in total.

To tighten, use one wrench to hold the Male connector in place and a second wrench on the

Female Quick-Connect Fitting to tighten it; tighten to 10 to 11 lbf-ft / 13 to 15 N-m.