Instructions / Assembly

ManualsBrandsQuickJack ManualsAutomotiveBL-7000SLX 7,000 lbs. Capacity Portable Car Lift

Table Of Contents

QuickJack Manual
Table of Contents
Introduction
Shipping
Safety
- Important Safety Instructions
- QuickJack Safety Information
- Symbols
- Liability Information
Components
Accessories
- SUV and Light Truck Adapter Kit
- SLX Frame Extension Kit
- Motorcycle Lift Adapter Kit
- Ranger RML-1100 Motorcycle Jack
- JackPak
Specifications
Frequently Asked Questions
Setup Checklist
Setup
- Setup Safety Rules
- Tools
- Selecting a Site
- Unpacking
- Clearances
- QuickJack Assembly Kit
- Air and Hydraulic Cylinders
- Installing the Hydraulic Elbow Fittings
- Preparing the Short Hydraulic Hoses
- About Quick-Connect Fittings
- Routing the Short Hydraulic Hoses
- Preparing and Connecting the Long Hydraulic Hoses
- Pressurizing the Air Cylinders
- Find a Location for the Power Unit
- Installing the Hydraulic Fittings on the Power Unit
- Connect the Power Unit to a Power Source
  - Power Sources for VAC Power Units
    - 110 VAC Power Unit
    - 220/240 VAC Power Unit
  - Power Sources for 12 VDC Power Units
    - 12 VDC Power Unit
- Filling the Hydraulic Fluid Reservoir on the Power Unit
- Check the Breather Valve
- Connect the Hydraulic Hoses
- Bleeding the Hydraulic Cylinders
- Final Checklist Before Operation
- Test the QuickJack
- Leave the Manual with the Owner/Operator
Operation
- Safety
- About Lift Blocks
- Special QuickJack Warnings
- Positioning the Lift Blocks and Frames
- Raising the QuickJack Frames
- Lowering the Frames from the First Locking Position
- Lowering the Frames from the Top Locking Position
- Using the 12 VDC Power Unit
- Additional Operating Information
- Hydraulic System Warnings
Maintenance
- Lubrication Points
- About Outdoor Operation
Troubleshooting
- Frames at Full Height with No Load
- Vehicle with No Tires Fully Lowered
- Priming the Pump
Wiring Diagrams
- 12 VDC Wiring Diagram
- 208-230 VAC Wiring Diagram
Labels
Parts Sheets
Automotive Lift Institute (ALI) Store
Maintenance Log
CE Documentation

QuickJack™ Portable Car Jack 20 P/N 5900959 — Rev. J3 — Oct. 2019

Installing the Hydraulic Elbow Fittings

You need to install one Hydraulic Elbow Fitting on each Hydraulic Cylinder.

To install a Hydraulic Elbow Fitting:

1. Remove the shipping plug from the Hydraulic Cylinder Port using a 6 mm hex key.

2. Get an Hydraulic Elbow Fitting from the QuickJack Assembly Kit; screw the O-ring fitting end into

the Hydraulic Cylinder Port.

Tip Raising the QuickJack Frame and putting a Lift Block under it or manually raising

the Platform to a locking position can provide a little bit of extra room, making it

easier to secure the Hydraulic Elbow Fitting.

Important: Do

not

use Thread Seal Tape on either end of the Hydraulic Elbow Fitting.

3. Position the threaded fitting end as shown above; accessible but not pointed up.

You want the threaded fitting end accessible but

not

pointed up, as the Short Hydraulic Hose

would then angle up and could possibly impact the underside of a Vehicle.

4. Tighten the fitting nut to 11 to 12 lbf-ft / 14 to 16 N-m.

5. Perform the same process for the Hydraulic Cylinder on the other QuickJack Frame.