Instructions / Assembly

Motorcycle and ATV/Motorcycle Lift Adapter Kits 9 P/N 5900054 —Rev. B — April 2019
Setup
⚠ WARNING Do not use the Lift Adapter Kit where the slope of the floor is greater than 3
degrees; this makes it much more likely that the load on the platform will become
off balance and fall, potentially damaging the platform, the QuickJack, or any
people in the vicinity. Make sure to wear appropriate work clothing while setting up
the Lift Adapter Kit, including gloves and steel-toed work boots.
To set up your Lift Adapter Kit:
1. Unpack. The platform and the clamp assembly come in separate boxes. Open them in the area
where you plan to assemble the unit.
2. Attach the clamp assembly to the platform. Use the provided nuts and bolts to attach the
clamp assembly to the platform. Refer to the graphic in the System Components section to see
where the clamp assembly attaches to the platform.
We recommend attaching the right side (the non-handle side) of the clamp assembly first.
3. Attach the tie-downs. If you plan on using the provided tie-downs to help secure your vehicle,
attach them to the platform.
4. Put the platform on your QuickJack frames. If you are going to use your Lift Adapter Kit
right away, move your QuickJack frames together and position the platform on top of the frames.
Be sure the lock bars on the QuickJack frames are on the outside.
Important: Orient the platform so that the ramp is over the large square labels on the
QuickJack frames. The platform does not fit correctly if you put the clamp end over
the labels.