Instructions / Assembly

QuickJack™ Portable Car Jack 9 P/N 5900263 — Rev. B1 — September 2021
• Parts Bag. Holds the components used during setup; includes the Hydraulic Fittings.
• Two Power Unit Quick-Connect Fittings. One end connects to the Long Hydraulic Hose,
while the other end connects to a Hydraulic Port on the Power Unit.
• Two Male Quick-Connect Fittings. One end connects the Short Hydraulic Hose, and the
other end connects to the Long Hydraulic Hose.
• Four Female Quick-Connect Fittings. One goes on each end of the Long Hydraulic Hose.
Two per each Long Hydraulic Hose.
• Two Short Hydraulic Hoses. Connect on one end to the Hydraulic Cylinder on each Frame
and on the other end to one of the Long Hydraulic Hoses. Note that the Short Hydraulic Hoses
must be routed under the bottom of the Frame, never over the Frame.
• Two Long Hydraulic Hoses. Connect on one end to the Power Unit and on the other end to
one of the Short Hydraulic Hoses.
Tip To move your QuickJack components: disconnect the Long Hydraulic Hoses either
at the Power Unit or at the Short Hydraulic Hoses. This is easier than trying to move
the QuickJack with all components connected.
• Two Frame Positioning Handles. Used to easily move the QuickJack Frames, usually to
position the Frames under the Vehicle’s factory-recommended Lifting Points.
• Lock Bars. The two Lock Bars, one on each QuickJack Frame, hold the Frames in position when
they are raised.
Only leave the QuickJack either fully lowered or engaged on a Locking Position.
• Hydraulic Cylinder and Air Cylinder. Each QuickJack Frame has one Hydraulic Cylinder and
one Air Cylinder. The Hydraulic Cylinder receives Hydraulic Fluid from the Power Unit, which is
used to move the Frames up and down. The Air Cylinder acts like an air spring, which means they
assist in lowering the Frames.
• Wheels. The two Wheels on the non-sticker end of each QuickJack Frame allow you to easily
move the Frame to a different location. Note that the Wheels and the weight of the Frame can
leave marks on some floors, so be careful using them.
• Handles. On the sticker end of each QuickJack Frame is an opening that can be used as a
Handle when you are moving the Frame. To pick up a Frame by its Handle, with one hand raise the
Frame just off the ground under the large yellow sticker, then put the other hand in the Handle and
continue to raise the Frame.
⚠ WARNING Be very careful when putting down the Frame; you do not want to crush your
fingers.