Instructions / Assembly

QuickJack™ Portable Car Jack 8 P/N 5900263 — Rev. B1 — September 2021
Components
The following image shows the main components of a QuickJack.
Not all components shown. Not necessarily drawn to scale.
QuickJack components include:
• Two QuickJack Frames. The Frames, working together, raise and lower Vehicles.
The two Frames are
not interchangeable. The Lock Bars, described below, must be on the
outside when you orient the Frames.
• Eight rubber Lift Blocks. Four are medium height (2 inches) and four are tall (3 inches high).
The Lift Blocks can be placed in different locations in the Receiver Trays, allowing you to hit the
factory-recommended Lifting Points on a wide variety of Vehicles. Always use Lift Blocks; do not
raise a Vehicle on just the QuickJack Frames.
Note: You can stack one medium and one tall block together, but not more than that.
If you have a Vehicle with a unibody/pinch-weld frame, QuickJack recommends ordering optional
Pinch-Weld Blocks, available on the QuickJack website. If you have an SUV or truck, there
is an SUV and Light Truck Adapter available for these Vehicles, also on the QuickJack website.
If you are going to be raising Vehicles with very low ground clearance, low-profile Lift Blocks are
available as Accessories.
• One Power Unit (includes Pendant Control). Not shown. Provides power to the QuickJack
Frames. There are five Power Units available: 110 VAC, 220/240 VAC, CE-approved 220 VAC, 12
VDC, and CE-approved 12 VDC.