Instructions / Assembly

QuickJack™ Portable Car Jack 48 P/N 5900263 — Rev. B1 — September 2021
Maintenance
Refer to ANSI/ALI ALIS Standard (R2015) Safety Requirements for Installation and Service of
Automotive Lifts for more information about safely servicing your QuickJack.
⚠ WARNING Disconnect power from your QuickJack before performing any maintenance! The
QuickJack must be de-energized and you must take steps to make sure that it
cannot be re-energized until all maintenance is complete.
Reorder labels and worn, damaged, or broken parts from quickjack.com/replacement-parts.
Only use factory-supplied parts as replacement parts.
All maintenance tasks can be performed by the owner/operator of the QuickJack.
To maintain your QuickJack:
• Daily. Make a visual inspection of all moving parts and check for damage or excessive wear.
Replace any damaged or worn parts before equipment is put back into operation.
• Daily. Keep all QuickJack components clean.
• Daily. Make sure the Safety Locks are in good operating condition. Do not use your QuickJack if
the Safety Locks are damaged or excessively worn.
• Daily. Inspect Lift Blocks for damage or excessive wear. Replace as required.
• Weekly. Check all hose and fitting connections to make sure they are tight.
• Monthly. Lubricate all hinge points and check for excessive wear.
• Monthly. Check Air Cylinders to make sure they have the correct amount of pressure.
• Every other month. Check Hydraulic Fluid levels and refill if required.
• When noticed. Replace all caution, warning, and safety-related labels if illegible or missing.
Lubrication Points
QuickJack recommends using white lithium grease (or equivalent) and a grease gun with an
appropriate tip (a Lube-Link™, for example) for lubrication. Lubrication points are shown below.