Instructions / Assembly

QuickJack™ Portable Car Jack 43 P/N 5900263 — Rev. B1 — September 2021
Do not lower the Release Cam / Lock Bar if the Release Cam is in the Up
position
, as shown below. The Release Cam needs to be in the Down position, as shown in the
drawing on the previous page.
If the Release Cam is in the Up position, carefully use your hand to move it to the Down position.
Not necessarily to scale. Not all components shown. Release Cam shown in the Up position,
which must be changed to the Down position before lowering.
If one side re-engages on the Lock Block but the other does not, immediately release Down,
press and hold Up, go further past the Lock Block, release Up, and then press and hold Down. If
this issue continues, refer to Troubleshooting.
Note: QuickJack recommends pressing Down for ~5 seconds
after the Frames are on the
ground; this ensures that as much Hydraulic Fluid as possible returns to the Fluid Reservoir.
3. Remove the QuickJack Frames from underneath the Vehicle; you may want to use the Quick
Frame Handles.
4. Move the Vehicle, if desired.
⚠ CAUTION Do not drive on the QuickJack Frames or the Hydraulic Hoses.